Well I'm new to this forum, not to RC though. Anyway, I've been rebuilding my Team Associated SC10 RWD's diff and have just put the tranny back together. I used thread lock on the screws as you should.
But the main question is, should the input shaft be easily rotatable by your hands?
The reason I ask this is because I may have used too much thread lock. When putting the casing together, it was oozing out the sides, so my guess is that it was going inside as well. If the input shaft is meant to be easily rotatable (mine certainly isn't), have I just completely locked up my transmission with the thread lock? Would highly appreciate any help I can get.
Thanks,
But the main question is, should the input shaft be easily rotatable by your hands?
The reason I ask this is because I may have used too much thread lock. When putting the casing together, it was oozing out the sides, so my guess is that it was going inside as well. If the input shaft is meant to be easily rotatable (mine certainly isn't), have I just completely locked up my transmission with the thread lock? Would highly appreciate any help I can get.
Thanks,