I have an mbx7 roller. Nice and fresh. All out drives and shafts are in good condition. Center shafts have 1 practice run on them. No slop very tight set up. Brand new bitty design stealth wing. Bitty design body has a couple runs on it. M2C pivot brass weights originals included. Center diff, brakes, radio box and servo tray all mbx7r. Green sealed boca lightning bearings installed at every bearing. Will include the losi 1400 mah nimh rx pack installed.
Spares included:
Front lower and upper arms NEW
Rear arms and hubs NEW
Front and rear 44t diff gears
12 pack air filters NIP
1 piece motor mount installed and 2 piece included
2 sets of springs front and rear
NIP fuel tank
Hinge blocks
Used but not worn out front or rear drive shafts
3 shoe clutch with shoes no flywheel nut or collet
Whatever is pictured is included except the pit mat and the miller lite in the yeti..
Looking to get $350 shipped or possibly trade for an sct410 or scte thats it!! Any questions shoot me a PM I'll get to it promptly. Thanks for looking!
![]()
![]()
![]()
![]()
![]()
![]()
![]()
![]()
![]()
![]()
Spares included:
Front lower and upper arms NEW
Rear arms and hubs NEW
Front and rear 44t diff gears
12 pack air filters NIP
1 piece motor mount installed and 2 piece included
2 sets of springs front and rear
NIP fuel tank
Hinge blocks
Used but not worn out front or rear drive shafts
3 shoe clutch with shoes no flywheel nut or collet
Whatever is pictured is included except the pit mat and the miller lite in the yeti..
Looking to get $350 shipped or possibly trade for an sct410 or scte thats it!! Any questions shoot me a PM I'll get to it promptly. Thanks for looking!
